ATC200 LITE DRIVER

Now the device formerly on 6 will be on The top unit is installed at the top of the tower, below the Teletilt RET remote electrical tilt devices. Isolated from dc return and ground. See Table for pin outs. Right click on port 6. Driver Software is Up To Date.

Uploader: Samuzuru
Date Added: 26 October 2009
File Size: 65.56 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 65479
Price: Free* [*Free Regsitration Required]

Good Damaged Figure These AISG compliant connectors have locking screw—rings and are keyed to provide a matching fit with the ports on the actuator, controller, and other RET devices. Cable should never be cut to change genders.

Enter IP address of controller. To check, enter FTP: Failure to assure installations are done properly by trained installation personnel and to follow procedures discussed in this bulletin may cause warranty for such products to be void. Both units also provide signal level conversion from RS— used on a PC to RS— used in ATM actuatorsas well as power to the actuators that are at200 to the antennas. Select a free com port with number greater than 8. See Table for pin-out.

  HYDRAFORCE DUAL SOLENOID DRIVER

The male connector should be attached towards the bottom end component output sideand the female connector should be attached at the top end component input atc2000. Click on the link for the product of interest. View versions and download the latest RET controller software and firmware, quickly access installation information, and download operation guidelines.

Andrew Atc – Lite USB Ret Controller | eBay

Improper Site Installation – Example 1. Your Local Area Connection Status window will open. Choose Turn off Pop-up Blocker. Wait for programs to be listed. If the address is unknown, life can be found by using a serial cable. For cases where you are unable to contact any devices and a TMA and bottom smart bias tee are used: The bottom unit is installed at the base of the tower.

Andrew Atc200 – Lite USB Ret Controller

Verify antenna is OK by certifying that tilt rod moves freely about lbs. Open Word and paste Atf200 V. If the hardware error alarm still persists, allow the device to cool for ten minutes and try to tilt again. Now the device formerly on 6 will be on Male AISG connects towards the controller. Right click on port 6.

  BAMBOO FUN CTE 650 DRIVER DOWNLOAD

Actuator Modes and Antenna Suffixes. Found New Hardware Wizard: Coax Ground Outer Cond.

ATCLITE-USB Teletilt Portable RET RS to RS RET Controller – Talley Inc.

Failure to conduct pre-test and preinstallation procedures defined by Andrew will void warranty. Select Manage Network Connections link Figure Contact Andrew Customer Support.

Local Area Connection Properties.

Andrew installation instructions are written for such installation personnel. Click on the link provided for Installation and User Guides Figure Selecting Browse my computer for driver software. See Litee for an example of the primary components used in a RET system.

Author: admin